Every bin here is ours — we make it and we pack itSizes measured at our own bench, not copied from a cataloguePrice on the label is the reading we took, with its date
PATIKILOffice, craft and home improvement accessories, made by us
Pipe Fitting 45 Degree Short Radius Tube Connector Sweat Solder — PATIKIL

Plumbing, pneumatics & electrical

Pipe Fitting 45 Degree Short Radius Tube Connector Sweat Solder

4.0 5 notes

$9.40Low on the shelf

  • Made from pure copper
  • 6.35 mm (1/4 inch) inner diameter
  • Short radius for tight spaces
  • For M, L, or K copper tubing

Pick the size or colour

The stamp below follows whichever option is lit.

The stamp hands you over to the listing where this bin is actually sold. The price and the stock state you see there are the ones that count.

What this bin holds

These 45-degree short radius copper fittings are for connecting tubes. They make secure, leak-free joints through sweat soldering.

Our fittings are made from pure copper, making them durable and long-lasting. Each fitting has a 6.35 mm (1/4 inch) inner diameter and is 0.8 mm (0.03 inches) thick. The short radius design helps us install them in tight spaces, and the sweat solder connection ensures a secure, leak-free joint. We pack them in sets of eight.

The numbers on the label

What the label says
AislePlumbing, pneumatics & electrical
Options in this bin5 sizes and colours
ColorCopper Tone
MaterialCopper
Inner diameter6.35mm / 1/4 inch
Thickness0.8mm / 0.03 inch
Packing list8 Pcs x Copper Fitting
Price across options$9.40 to $19.85
Rating on the listing4.0 from 5 notes

Who takes it home

We use these copper fittings in water supply lines, HVAC systems, refrigeration, and water heating. They work with M, L, or K type copper tubing. Remember that the size we list is the actual inner diameter, not the nominal pipe size, so measure your tubing's outer diameter for a correct fit.

Next to it on the shelf

Walk the rest of Plumbing, pneumatics & electrical — 436 bins in all. Fittings, hose, terminals, filters.

Pipe Fitting 45 Degree Short Radius Tube Connector Sweat Solder $9.40

What makers wrote about this bin

  • Worked great where I accidentally kinked 3/4" HVAC tubing when bending 90 deg (yes, I used a good bender), so cut a section out and silver-solder this 45 elbow in. I think it would also fit 5/8" plumbing tubing (sized by nominal ID).

    Bill Grissom · 5 of 5

  • These worked perfectly to what was needed. Our water fall thanks you.

    CindyLee · 5 of 5

Next along the same shelf

Pipe Fitting 45 Degree Short Radius Tube Connector Sweat Sol$9.40