Every bin here is ours — we make it and we pack itSizes measured at our own bench, not copied from a cataloguePrice on the label is the reading we took, with its date
PATIKILOffice, craft and home improvement accessories, made by us
Jobber Straight Shank — PATIKIL

Fasteners & cutting tools

Jobber Straight Shank

4.6 192 notes

$6.09On the shelf

  • Four 1mm jobber drill bits
  • M2 high-speed steel with TiN coat
  • 12mm flute, 34mm overall length
  • For medium to high hardness metals

Pick the size or colour

The stamp below follows whichever option is lit.

The stamp hands you over to the listing where this bin is actually sold. The price and the stock state you see there are the ones that count.

What this bin holds

Our jobber drill bits are designed for general-purpose drilling, making clean holes in a range of metals. We offer many sizes for your shop.

This bin holds four 1mm cutting diameter drill bits, each with a 12mm flute and 34mm overall length. They are crafted from M2 high-speed steel for hardness and wear resistance, then coated with titanium nitride to protect against oxidation and corrosion. The 135° split point tip helps keep the bit on target.

The numbers on the label

What the label says
AisleFasteners & cutting tools
Options in this bin62 sizes and colours
Packing list4 packs of drill bits in 1mm cutting diameter, 12mm/0.47inch flute length, 34mm/1.34inch o
Price across options$6.09 to $41.99
Rating on the listing4.6 from 192 notes

Who takes it home

Metalworkers and fabricators reach for these bits for drilling low- and medium-carbon steel, alloy steel, stainless steel, cast iron, and aluminum alloys. When you start drilling, position the twist drill at a 90° angle to your workpiece to avoid wandering.

Next to it on the shelf

This bin lives in Fasteners & cutting tools, one of 215 on that aisle. Washers, screws, blades, files.

Jobber Straight Shank $6.09

What makers wrote about this bin

  • Purchased this for a specific use. I dabble with golf club repair, and when replacing shafts, sometimes the only way to remove the old shaft is to bore out the hosel . Many woods use shafts with .335 diameter tips, so an 8.5 mm bit matches that size within .00035 of an inch. This is much closer than you can get to the exact hosel bore size than using a bit delineated in 32nds of an inch, or even 64ths. So this bit allows cleaning the hosel bore to almost its exact original size and cleaning out all old shaft material without enlarging it. For a specialty use like this, the 8.5mm drill bit is…

    Gregory S. Wanner · 5 of 5

  • Work great in wood. Surprised when I discovered there were two in the package.

    Q. D. · 5 of 5

  • Works as designed!

    ASIMERAL · 5 of 5

  • excelente

    pedro m. · 5 of 5

Next along the same shelf

Jobber Straight Shank$6.09